Siemens 200 P633 LCD Totalized Decimal Position MR, P640 Remote Totalized Multiplier MR, 100 1000

Parameters

P633 LCD Totalized Decimal Position [MR 200]

Enter the maximum number of decimal places to be displayed.

Primary Index		Single Point Model			Dual Point Model
	Global				Transducer
	0			no digits after the decimal point
Values	1			1 digit after the decimal point
	2		*	2 digits after the decimal point
	3			3 digits after the decimal point
Related	•	LCD Totalizer (P322 and P323)

Note: Set the decimal position during initial commissioning of the MultiRanger

200.If the position is changed later, the totalizer data in P322 and P323 will be incorrect and must be reset according to the new decimal value.

In RUN mode, the number of decimal places displayed is not automatically adjusted. When the LCD Total value is so large as to exceed display capabilities, the total rolls over to 0 and continues incrementing.

P640 Remote Totalized Multiplier [MR 200]

Use this feature if the remote totalizer (device connected to the relay set for totalizer operation [relay Function, P111 = 40]), updates too slowly or rapidly.

Primary Index		Single Point Model			Dual Point Model
	Global				Transducer
	-3			.001
Values	-2			.01
	-1			.1
	0		*	1
	1			10
	2			100
	3			1000
Values
	4			10,000
	5			100,000
	6			1,000,000
	7			10,000,000
	•	P001 Operation
	•	P111 Relay Control Function
Related	•	P114 Relay Duration Setpoint
	•	P115 Relay Interval Setpoint
	•	P645 Relay Duration

Parameter is relevant only if Operation is set to OCM or Pumped Volume (P001 = 6 or 7). The relays on the MultiRanger have a maximum frequency of 2.5 Hz.

Page 176 MultiRanger 100/200 – INSTRUCTION MANUAL 7ML19981FB06