Testing the Configuration

Monitor system performance carefully, under all anticipated operating conditions.

1.When the MultiRanger performs exactly as required, programming is complete.

2.If alternate Reading units, Failsafe action, or relay operation is desired, update the parameters for the new functionality.

3.If the system performance experiences problems, see General Appendix C: Troubleshooting, on page 231.

If you cannot observe all possible operating conditions during the System Performance Evaluation, use the level simulation (see page 85) to verify programming.

When a simulation is run, alarm relays will react to the simulated level changes, but control relays will not react. You can set P000 to value –1 to trigger the control relays based on the simulated level.

Retest the system every time you adjust any control parameters.

Page 88

MultiRanger 100/200 – INSTRUCTION MANUAL

7ML19981FB06

Page 98
Image 98
Siemens 200 instruction manual Testing the Configuration