Sharp AR-C160 operation manual When the staple cartridge is empty, the message Slide

FINISHER (AR-FN4)

Staple cartridge replacement

When the staple cartridge is empty, the message “SLIDE THE

FINISHER AWAY FROM THE COPIER AND ADD STAPLES.” will appear.

Replace the staple as follows:

OPTIONAL EQUIPMENT7

Finisher (AR-FN4) CHAPTER

While holding the finisher release lever, slide the finisher

1 away from the copier.

Pull out the staple box.

2 ● To prevent bumping or scraping your hand during removal of the staple box, proceed as shown in the illustration and as follows:

Grasp the staple box with your thumb and index finger, and place the heel of your hand against the finisher frame as shown with arrow 1 in the illustration.

Remove the staple box in the direction of the arrow 2 by squeezing with your fingers and rotating against the heel of your hand.

Remove the empty staple cartridge from inside the

3 staple box.

Insert the new staple cartridge into the box until it clicks

4 in place.

●Insert the new cartridge by aligning the arrows on the cartridge with those on the box. Check that the cartridge locks in place by pulling it slightly.

●The cartridge holds 3,000 staples.

NOTE:

Be sure to remove the rear paper and tape before inserting the cartridge.

7-22