Sharp AR-C160 operation manual Interrupting a Copy RUN

INTERRUPTING A COPY RUN

CHAPTER2

INTERRUPT can be used to temporarily stop a long copy run so that another job can be run.

●INTERRUPT will not function during duplex copying (when an optional duplex module (AR-DU2N) is installed).

●Duplex copying, sort, group, staple sort and offset cannot be selected during interrupt copying. Also job program recall cannot be selected.

MAKING COPIES Interrupting a copy run

3

6

INTERRUPT

CLEAR CA ALL

1	Press the INTERRUPT key.
	● When the optional document feeder is being used, the copier will
	stop after copying any originals which have been fed into the
	document feeder. The INTERRUPT indicator will blink until the
	copier stops.
	When the copier stops, it will return to its initial settings and the
	INTERRUPT indicator will light steadily. At this time, the copier
	is ready for interrupt copying.
	● If the copier has been programmed in the auditing mode, the
	account number entry message will appear. Enter your account
	number using the 10-key pad. The number of copies of the
	interrupt copying will be accumulated against this account
	number.
	When the copier stops, remove the original(s) and set
2 the original(s) for interrupt copying on the document
	glass or in the optional document feeder tray.

3 INTERRUPT

6

CLEAR CA

ALL

9

PROGRAM C

P CLEAR

3 INTERRUPT

6

CLEAR CA

ALL

3	Select the desired available copier functions.
4	Press the COLOR COPY START (	) key or BLACK
	COPY START ( ) key.

When the interrupt copy run is complete, press the

5 INTERRUPT key again to cancel the mode and remove the original(s) used for interrupt copying.

●The copier will reset itself to the functions which were in use before the INTERRUPT key was first pressed.

Replace the original(s) for the interrupted job and press

6 the COLOR COPY START () key or BLACK COPY

START () key to resume copying.

2-20