Sharp AR-C160 operation manual Color balance settings

COLOR ADJUSTMENTS

READY TO COPY

OK

COLOR BALANCE CANCEL OK

C

M

N

1 2 3 INTERRUPT

4 5 6

CLEAR CA

ALL

7 8 9

AUDIT PROGRAM C

0 P CLEAR

3 INTERRUPT

6

CLEAR CA

ALL

9

PROGRAM C

P CLEAR

●The setting screen for COLOR BALANCE will appear.

		READY TO COPY.
		SPECIAL MODES			OK
		COLOR BALANCE		CANCEL	OK
		C
		M
		Y
		Bk
5							3CHAPTER
	Use these keys to select the color to be adjusted ( C					= cyan,
	Use the keys indicated in the illustration above to adjust
	the color balance settings.
		M = magenta, Y		= yellow, Bk	= black).
							SPECIAL
	If only the area around the letter inside a key is highlighted, the
	settings have been changed from the factory default settings.
	Use these keys to adjust the densities of each of the eight
	density levels.						FUNCTIONS
	When one of the keys is pressed, the corresponding indicator
	line will move up or down one step. Press the					key to
	increase the density of the corresponding level, or the					key
	to decrease the density.						Color
	Use these keys to change the densities of all eight levels at
	once.						adjustments
	When either key is pressed, the indicator lines of all eight levels
	will move up or down one step.
	Press the		key to increase the density, or the			key to

decrease the density.

Use this key to return the densities of all eight levels to the initial settings.

The initial color balance settings are the values set with key operator program “Initial Color Balance Setting”. For this reason, the initial settings may not necessarily be 0 (the middle indicator position) for all levels. The initial setting of each level is shown by a gray indicator. See page 22 of the KEY OPERATOR'S GUIDE.

Make all other desired copier selections and enter the

6 desired number of copies.

Press the COLOR COPY START ( ) key.

7 ● The BLACK COPY START () key can be pressed for copying. However, the COLOR BALANCE settings will be ignored.

●You can also store color balance settings for repeated use in the future. (Refer to “Storing a Job Program” on page 2-18). In this case, complete the color balance setting before pressing the PROGRAM key bacause color copy samples cannot be made after the PROGRAM key is pressed.

3-23