Sharp AY-XPC7JR Setting Air Purifying Filter, Tips On Saving Energy, Auxiliary Mode, GB-5

SETTING AIR PURIFYING FILTER

The air purifying filters are packed as accessory of this unit. During operation of the air conditioner, the filters remove dust and tobacco smoke from the air and discharges clean air.

1 Take out the air filters.

1 Open the open panel.

2 Push the air filters up slightly to unlock them.

3 Pull the air filters down to remove them.

1

23

2 Set the air purifying filter under the filter stoppers located on the air filter.

Filter stopper

Air purifying filter

Air filter

3 Reinstall the air filters.

1 Reinstall the air filters in the original posi- tions.

2 Close the open panel.

3 Push the arrow-marked of the panel firmly to lock it in place.

3

2

1

Precautions:

•The filters are sealed in a plastic bag to keep their dust collection effect.

Do not open the bag until using the filters. (Otherwise the filters life may get shorter.)

•Do not expose the filters to direct sunlight. (Otherwise they may deteriorate.)

TIPS ON SAVING ENERGY

Below are some simple ways to save energy when you use your air conditioner.

SET THE CORRECT TEMPERATURE

•Setting the thermostat 1°C higher than the desired temperature in the COOL mode and 2°C lower in the HEAT mode will save approximately 10 percent in power consumption.

•Setting the temperature lower than necessary during cooling operation will result in increased power consumption.

BLOCK DIRECT SUNLIGHT AND PREVENT DRAFTS

•Blocking direct sunlight during cooling operation will reduce power consumption.

•Close the windows and doors during cooling and heating operations.

SET PROPER AIR FLOW DIRECTION TO OBTAIN THE BEST AIR CIRCULATION

KEEP FILTER CLEAN TO ENSURE THE MOST EFFICIENT OPERATION

MAKE MOST OF THE TIMER OFF FUNCTION

DISCONNECT THE POWER CORD WHEN THE UNIT IS NOT USED FOR AN EXTENDED PERIOD OF TIME

•The indoor unit still consumes a small amount of power when it is not operating.

AUXILIARY MODE

Use this mode when the remote control is not available.

TO TURN ON

Lift the open panel of the indoor unit and press the AUX. button.

•The red OPERATION lamp ( ) on the unit will light and the unit will start operating in the AUTO mode.

•The fan speed and temperature setting are set to AUTO.

TO TURN OFF

Press the AUX. button again.

•The red OPERATION lamp ( ) on the unit will turn off.

AUX

NOTE:

•If the AUX button is pressed during normal operation, the unit will turn off.

ENGLISH

GB-5