Sharp FO-1530 Installation, Do not yet remove the band which holds the spools together 2 tabs

all-fo1530a.book Page 15 Tuesday, December 5, 2000 2:07 PM

3 Take the new film out of its package, and insert two of the gears provided with the fax into the ends of the spool with film. Make sure that the two tabs on the gears fit properly into the slots in the ends of the spool.

•Do not yet remove the band which holds the spools together.

2 tabs

4 Hold the empty spool so that the end with only one slot is on the left, and lower the spools into the front of the printing compartment. The gears in the ends of the spool with film should fit into the slots on each side of the printing compartment.

Loading the Imaging Film

5 Cut the band which holds the

spools together with scissors, and remove it. Insert the remaining gear into the right end of the empty spool and the flange into the left end of the empty spool. Make sure the tabs on the gear and the flange fit into the slots in the ends of the spool (the gear has two tabs and the flange has one tab).

1 tab

2 tabs

Gear

Flange

6 Pull the empty spool toward the

back of the compartment, unwinding the film as you pull.

15

1. Installation