Sharp FO-1530 operation manual Important safety information

all-fo1530a.book Page 3 Tuesday, December 5, 2000 2:07 PM

Important safety information

•For your safety, if any of your equipment is not operating properly or should any physical damage occur to the equipment where internal parts may become exposed, the equipment should be immediately disconnected from the phone line and then the power line and returned to a SHARP authorised Service Centre for inspection, repair, or disposal.

•In Australia, installing or modifying telephone lines should only be done by an ACA licensed serviceman. In New Zealand, installing or modifying telephone lines should be done in accordance with Telecom wiring practices.

•Do not disassemble this machine or attempt any procedures not described in this manual. Refer all servicing to qualified service personnel.

•This machine must only be connected to a 230-240 V, 50 Hz, earthed (3-prong) outlet. Connecting it to any other kind of outlet may damage the machine.

•Do not install or use the machine near water, or when you are wet. Take care not to spill any liquids on the machine.

•Unplug the machine from the telephone socket and then the power outlet and consult a qualified service representative if any of the following situations occur:

-Liquid has been spilled into the machine or the machine has been exposed to rain or water.

-The machine produces odors, smoke, or unusual noises.

-The power cord is frayed or damaged.

-The machine has been dropped or the housing damaged.

•Do not allow anything to rest on the power cord, and do not install the machine where people may walk on the power cord.

•Never insert objects of any kind into slots or openings on the machine. This could create a risk of fire or electric shock. If an object falls into the machine that you cannot safely remove, unplug the machine and consult a qualified service representative.

•Do not place this machine on an unstable cart, stand or table. The machine could be seriously damaged if it falls.

•Never install telephone wiring during a lightning storm.

•Never install telephone sockets in wet locations unless the socket is specifically designed for wet locations.

•Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

3