Memorising the remote control buttons

HT-CN300W

You can assign only one function to each button. If you assign two functions to the button, the newer one will be memorised (learn function).

Memorising operations in the Memory 2

buttons for other equipment

The same buttons are used for both Memory 1 and 2 operations. To store signals in Memory 1 buttons, set the MEMORY 1/2 selector switch to MEMORY 1, and for Memory 2 buttons, set the switch to MEMORY 2.

1 Set the MEMORY 1/2 selector switch to MEMORY 2.

2 Move the LEARN/TRANSMIT selector switch to LEARN.

The red learn indicator will light up. Though the red and green learn indicators light up alternately after approx. 15 seconds, you can go on to the next step.

Lights up

Alternately light up

 

 

 

 

3 Press down the desired button on the remote control for 2 seconds or more.

The green learn indicator will flash (the red indicator remains lit).

Lit Flashes

4 Within 10 seconds, press down for more than 2 seconds the

desired button on the remote control supplied with other equipment to send the signal to the marking.

Angle and distance

5 cm - 10 cm (2" - 4")

10˚

When the signal is sent to the remote control of the unit, the green indicator will go off. When memorisation is completed, it will light up.

Lit Goes off

Lit Lights up

mark

If the signal is not memorised correctly, the

red learn indicator will flash. Perform theFlashes operations from step 3 again.

5 Repeat steps 3 and 4 to memorise other buttons.

6 After memorisation is completed, move the LEARN/TRANSMIT selector switch to TRANSMIT.

You can use the remote control.

Notes:

zYou cannot store all the button operations by pressing only one button on the remote control of other equipment. Memorise them one by one.

zAfter storing operation is completed, check that other equipment works correctly with the remote control.

zSome functions cannot be memorised depending on other equipment.

Remote Control - Memorising the remote control buttons -

20

02/7/11 HT-CN300W_A_3.fm

Page 21
Image 21
Sharp HT-CN300W operation manual Remote Control Memorising the remote control buttons