Sharp HT-CN300W operation manual „ Setting the sleep timer

HT-CN300W

Timer and sleep operation (continued)

Features -

When the preset time is reached:

zPlayback starts automatically and the volume increases gradually.

zThe unit will enter the power stand-by mode one hour after the timer playback starts.

To reset or change the timer setting:

Perform "Setting the timer" from the beginning (page 32).

Cancelling the timer playback:

Timer is cancelled by turning the power on whilst in the timer stand-by mode.

Notes:

zOnce the time is set, the setting will be retained until a new time is entered.

zThe contents of the setting will be erased if the unit is unplugged or a power failure occurs. In such cases, set the timer again.

zYou can select the other source in step 2 of "Setting the timer", but this unit cannot set the timer of other equipment.

zWhen in the timer stand-by mode, the X-BASS button does not allow you to enter the demonstration mode.

4 Press the ENTER button.

The sleep timer indicator lights up.

5 Your system will enter the power stand-by mode automatically after the preset time has elapsed.

The volume will be turned down 1 minute before the sleep operation finishes.

At that time, you cannot change the volume.

Note:

You can select the other source in step 1 of "Setting the sleep timer", but this unit cannot set the sleep timer of other equipment.

Advanced - Timer and sleep operation

„Setting the sleep timer

You can set the unit to the power stand-by mode at the specified time.

1 Press the TUNER/BAND button.

Tune in to the desired station. (See page 27.)

2 Press the TIMER/SLEEP button repeatedly until "SLEEP" is displayed.

3 Press the or button to change the sleep time.

(Maximum: 3 hours/Minimum: 1 minute)

To confirm the remaining sleep time:

Press the TIMER/SLEEP button.

zThe remaining sleep time is displayed for about 5 seconds.

zYou can change the remaining sleep time whilst it is displayed by pressing the ENTER button (steps 3 - 4).

To cancel the sleep operation:

Press the ON/ (STAND-BY) button whilst the sleep timer is set.

To cancel the sleep timer without setting the unit to the stand-by mode, proceed as follows.

1Press the TIMER/SLEEP button.

2Within 5 seconds, press the ENTER button.

3Press the or button to select "SLEEP0:00", and press the ENTER button.

z3 hours - 5 minutes 5-minute intervals

z5 minutes - 1 minute 1-minute intervals

33

02/7/11 HT-CN300W_A_4.fm