(Continued)
CD Playback
Symptom | Possible cause | Remedy |
●Even though a disc has been loaded, “NO DISC” or “ERR” is dis- played.
●Playback stops in the middle of a track, or playback is not performed properly.
●Playback sounds are skipped.
●The disc is loaded
●The disc is very dirty.
●The disc which does not satisfy the standards.
●Is the unit located near excessive vibrations?
●Has condensation formed inside the unit?
●Load the disc with the correct side up.
●Clean the disc.
●Load the correct disc.
●Place the unit on a firm, level surface free from vibration.
●Remove the disc and leave the power turned on. The unit should function properly in about 1 hour.
MD recording and playback
Symptom | Possible cause | Remedy |
●A recording cannot be made.
●Is the MiniDisc protected against accidental erasure?
●Did you try to make recording on a
●Can you see the “DISC FULL” or “TOC FULL 
” message in the dis- play?
●( 
:number or symbol)
●Slide the accidental erase pre- vention tab back to its original position.
●Replace it with a recordable disc.
●Put in another recordable disc with recording space on it.
●Even though a disc has been loaded, “MD NO DISC” or “READ ERR” is displayed.
●Playback sounds are skipped.
●The disc is very dirty.
●Is the unit located near excessive vibrations?
●Has condensation formed inside the unit?
●Clean the disc.
●Place the unit on a firm, level surface free from vibration.
●Remove the disc and leave the power turned on. The unit should function properly in about 1 hour.
Radio reception
Symptom | Possible cause | Remedy |
● Radios make unusual noise con- | ● The unit is placed near the TV or | ● When the unit receives a radio |
secutively. | computer. | broadcast near a TV set, a com- |
| ● The aerial direction is not placed | puter or a |
| properly. | pick up noise. If this hap- |
|
| pens,try to move the unit from |
|
| the place where the noise is |
|
| picked up. |
|
| ● Correct the aerial direction. |
● The preset channel cannot be re- | ● Did you erase the programmed sta- | ● Preset the channel again. |
called. | tion? | ● Redio programming. |
|
| |
|
|
|
Remote control
Symptom | Possible cause | Remedy |
● The remote control does not func- | ● The batteries (polarity) are not in- | ● Insert properly. |
tion or does not operate properly. | serted properly. | ● Replace the batteries. |
| ● The batteries inside the remote con- | ● Operate it within a range of 0.2 |
| trol are dead. | m (8") to 6 m (20’) and within |
| ● The remote control is operated from | an angle of 15 ° to either side of |
| an incorrect distance or angle. | centre. |
|
|
|
● The power cannot be turned on | ● Is the AC power lead plugged in? | ● Connect the AC power lead. |
from the remote control. |
|
|
|
|
|
46
