Sharp MX-M363U, MX-M453U, MX-M503U (2) Touch the [Erase] key., (3) Set the erasure width to15 mm with the keys.

67
SELECTING A SPECIAL MODE
The procedure for selecting a special mode for fax is explained below.
The settings that must be selected vary for each special mode, however, the general procedure is the same. The
procedure for erasing shadows at the edges of the image when sending a fax is explained below as an example.
1Place the originals.
When using the document glass, place the
original with the side to be scanned face down.
2Select settings in the touch panel.
(1) Touch the [Special Modes] key.
(2) Touch the [Erase] key.
The erase settings will be configured to
erase a width of 15 mm around the edges
of the original.
(3) Set the erasure width to15 mm with
the keys.
The erase area is set to "Edge Erase" by
default.
To select "Centre Erase", "Edge+Centre
Erase", or "Side Erase", touch the
appropriate key.
(4) Touch the [OK] key.
3Enter the fax number of the receiving
fax machine and press the [START]
key.
The side to be scanned must be face up!
OK
Dual Page
Scan
Card Shot
2in1
Erase
Timer
Program
Fax
Special Modes
1/3
Quick File
File
Special Modes
Sub Address
Address Book
Resend
Speaker
Send
Auto
Ready to send.
Fax
Image
Settings
Memory TX
Direct TX
Auto Reception
Fax Memory:100%
Scan
Special Modes
OK
OK
Cancel
15 (0~20)
mm
Edge
Edge+Centre
Erase
Edge
Erase
Erase
Mode Switch A4
(1)
(2)
(3)
(4)
Cancel scanning