Sharp UX-D50 manual 131, FAX RX in Memory

all.book Page 131 Monday, September 1, 2003 3:46 PM

Messages and Signals

FAX RX IN MEMORY	A fax has been received in memory because the
	imaging film needs replacement, you have run out of
	printing paper, or the paper is jammed. The fax will
	print out automatically when the problem is fixed.
FUNCTION MODE	The FUNCTION key has been pressed.
HOLD	The HOLD key has been pressed to place a call on
	hold. Press the HOLD key again to resume the call.
INCORRECT FILM/	The wrong type of imaging film is loaded in the
CHECK FILM	machine. Printing is not possible. The machine can
	only print when SHARP UX-9CR imaging film is
	loaded.
INTERCOM	A cordless handset is paging the fax machine (lift the
	handset to talk), or the fax machine is paging a
	cordless handset. The name and number of the
	cordless handset appear alternately with INTERCOM.
LINE ERROR	Transmission or reception was not successful. Press
	the STOP key to clear the message and then try
	again. If the error persists, see Line Error on page
	124.
MEMORY IS FULL/	The memory is full. You may have too many
SEE MANUAL	messages recorded in the answering system. To
(alternating messages)	erase messages, see page 68.
	This message may also occur during fax reception if
	too much data is received before the pages can be
	printed out. If faxes have been received to memory
	because printing is not possible (an additional
	message will indicate the problem), resolve the
	problem so that printing can continue (see Substitute
	Reception to Memory on page 105). If you are
	attempting to transmit from memory, see If the
	memory becomes full on page 96. If you are copying,
	see If MEMORY IS FULL appears on page 106.
MEMORY PRINTING	The fax is preparing to or printing out a document
	from memory.
NEAR END OF FILM/	This message appears 3 m from the end of the
REPLACE FILM	imaging film (approximately 10 pages can still be
	printed), and alerts you that you will soon need to
	replace the film.
	131

10. Trouble- shooting