Sharp XG-SV100W Setting Up the Projector Network Environment “Net.” Menu, Setting a Password

Setting Up the Projector Network Environment (“Net.” Menu)

	Picture Audio	SIG	SCR	PRJ	Net.
	Password			Disable
	DHCP Client			Off

TCP/IP

 Reset Network Setting

Restart Network

	IP Address	XXX.XXX.XXX.XXX
	MAC Address	XX:XX:XX:XX:XX:XX
	Projector	XX-XXXX

SEL./ADJ.	ENTER
RETURN	END

1 Setting a Password

If you do not want others to change the setting for the “Net.” menu, set a password.

a Setting a Password

1 Select “Password”, then press Q.

•The screen for entering the password appears.

Net.

Setting the Password
Old Password	– – – –
New Password	–	–	–	–
Reconfirm	– – – –

2Press P or R to set the first digit

in “New Password”, then press Q.

3 Enter the remaining 3 digits, then press ENTER.

• To return to the previous digit, press O.

4 Enter the same password in “Reconfirm”, then press ENTER. • The status for “Password” changes to

“Enable”.

Note

•Once after the password is set, you must enter the password to change the “Net.” menu settings.

Menu operation n Page 46

a Changing the Password

1 Select “Password”, then press Q.

•The screen for entering the password appears.

2 Enter the password in “Old Password” using P, R, Q and O, then press ENTER.

3 Enter the password in “New Password” using P, R, Q and O, then press ENTER.

4 Enter the same password again in “Reconfirm” using P, R, Q and O, then press ENTER.

Note

•If you do not need the password protection for the “Net.” menu settings anymore, press ENTER without entering new password in steps 3 and 4.

•To cancel the password settings, press

RETURN.

If you forget the password

If you forget the password, perform the following procedure to delete it, then set a new password.

On the projector, press

.

Note

•If ENTER is held down for more than 5 seconds, the operation buttons on the projector will be locked. (See page 58.)

•You cannot use the buttons on the remote control to delete the password.

Features Useful

61