Sharp XG-SV200X, XG-SV100W appendix Troubleshooting Continued, 69, 70, 70, 73, 22-26

Models: XG-SV100W XG-SV200X

1 92
Download 92 pages 27.45 Kb
Page 86
Image 86
Troubleshooting (Continued)

Troubleshooting (Continued)

Problem

Check

Page

 

 

 

Maintenance indicator on

• See “Maintenance Indicators”.

70

the projector illuminates

 

 

or blinks in red.

 

 

Picture is green on

• Change the input signal type setting.

52

COMPUTER (YPbPr)

 

 

 

 

 

Picture is pink

 

 

(no green) on

 

 

COMPUTER (RGB)

 

 

Picture is too bright and

• Image adjustments are incorrectly set.

48

whitish.

 

 

 

 

 

The cooling fan becomes

• When temperature inside the projector increases, the cooling fan runs

8, 9

noisy.

faster.

69, 70, 71

 

 

 

The lamp does not light

• The lamp indicator is illuminating in red.

70, 73, 74

up even after the

Replace the lamp.

 

projector turns on.

 

 

 

 

 

The lamp suddenly turns

 

 

off during projection.

 

 

 

 

 

The image sometimes

• Cables are incorrectly connected to the projector or the connected

22–26

fl ickers.

equipment works improperly.

 

 

• If this happens frequently, replace the lamp.

73

The lamp needs much

• The lamp will eventually need to be changed.

73

time to turn on.

While the remaining lamp life draws to a close, replace the lamp.

 

 

 

 

Picture is dark.

 

 

The remote control

• Operate the remote control while pointing it at the projector's remote

15

cannot be used.

control sensor.

 

 

• The remote control may be too far away from the projector.

 

 

• When using the ceiling-mount rotating module (AN-SV100T) and

 

rotating the projector, the signal transmission to the sensor may not

 

 

work depending on the rotation angle of the projector.

 

 

• If direct sunlight or a strong fl uorescent lamp is shining on the

 

 

projector's remote control sensor, place the projector where it will not

 

 

be affected by strong light.

 

 

• The batteries may be depleted or inserted incorrectly. Make sure the

15

 

batteries are inserted correctly or insert new ones.

 

The Rotate indicator does

• Is “Off” selected in “Rotate Indicator” ?

59

not light up.

• Check the connection of the ceiling-mount rotating module (AN-SV100T)

 

and projector.

 

The lens shift function

• The lens cover is not attached correctly.

12

does not work.

 

 

82

Page 86
Image 86
Sharp XG-SV200X, XG-SV100W appendix Troubleshooting Continued, 69, 70, 70, 73, 22-26