Sharp XG-SV100W Attaching the Ceiling Mount to the Ceiling, When installed with the AN-TK201

Attaching the Ceiling Mount to the Ceiling

When installed with the

AN-TK201

1Attach the ceiling mount to the

ceiling.

• First, lightly screw an installation bolt into the smallest hole and then proceed, doing the same for the holes , and .

Once the position has been decided, fi rmly tighten all four bolts.

•Use M8-type bolts. (Bolt type may vary depending on the method of installation.)

Washer

• Use the washers supplied with the	Mounting bolt (M8-type)
ceiling mount.

2Attach the height-adjustment pole to the ceiling mount.

1.Insert the height-adjustment pole into the ceiling mount.

2.Fix the pole in place with the sleeve and pole-fi xing bolt , according to the height of the screen.

3.Lock the bolt in place with the securing nut .

4.Screw in the two stabilizing screws .

5.Tighten the securing nut fi rmly and fi t the pin into the hole on the pole-fi xing bolt.

Pin hole Sleeve

Caution

•Ask your dealer or service shop to install the ceiling mount. Sharp will assume no responsibility whatsoever if inadequate installation causes your projector or attached devices to fall out of place.

Appendix

79