Galaxy H7920 Mobile Router User Manual | Chapter 3: Router Configuration |
|
|
System Log
Click
There are two options:
"Local Log": tick it on to log router operation information at router's memory. Hongdian does not recommend ticking it on at the normal operation.
"Remote Log": tick it on to send router operation information to a specified IP host that runs a syslog daemon.
Press "Save" button to save the selections. Press "Clean" button to delete all logs stored in Galaxy router.
Restart
Click
3.2.4 Network Setting
Galaxy router should be configured with proper parameters. Network setting is the basic and necessary configuration. Generally, LAN interface, mobile access parameters and dial mode should be configured.
The router LAN interface, IP address and subnet can be modified if necessary. At the initial phase, the PC that will connect to Galaxy router should be configured as same as the router’s IP subnet (192.168.8.x/255.255.255.0, here x=2 to 254). For more information regarding the PC IP address setting, refer to this manual Paragraph 3.1. Once your PC is set up properly, open IE browser and input Galaxy router LAN IP address to start the configuration.
Click “Start” > "Network Setting", the below picture will be displayed.
Galaxy H7920 Mobile Router User Manual | Chapter 3: Router Configuration |
|
|
There are four
Network Basic Setting
DHCP Configuration
SNMP Configuration
Dynamic DNS
Network Basic Setting
Click
LAN Setting
There are three LAN IP addresses and subnets that can be utilized. However, the host (or PC) that connect with Galaxy router should be configured at the same subnet as one of the three LAN addresses setting.
First LAN IP address (default): 192.168.8.1, subnet: 255.255.255.0
It can be modified in accordance with the requirement.
27 | 28 |
