Sherwood R-863 manual Universal Remote Controls, Digi Link System Remote Controls, English

ENGLISH

Universal Remote Controls

Note: For enhanced Universal Remote Programming instructions and manufacturer’s codes, please refer to the operating manual inclosed with this Universal Remote Control.

This remote control has 3 operating modes as follows:

•OSD (On-Screen Display) mode: Allows you to look at information about basic operation of this unit on your monitor TV and to operate this unit by moving an arrow that appears on the screen of your monitor TV.

•Sherwood mode: Allows you to operate this unit and other Sherwood components like cassette decks, CD players, etc.(To operate other Sherwood components, you should make the DIGI LINK connections between them.)

•Non-Sherwood mode: Allows you to operate other non-Sherwood audio and video components that are remote compatible.

Notes:

•The setup code for each component must be entered before operation.

•For setup codes(manufacturer’s codes), please refer to “Set-Up Code Tables” in the operating manual of this remote control.

•Some operation buttons have different functions according to each operation mode.

•Be sure to set the remote control to the correct mode before operation.

DIGI LINK SYSTEM REMOTE CONTROLS

•This section explains the basic functions for Sherwood or OSD mode. For the non-Sherwood mode, refer to the operating manual of this remote control.

•All Sherwood components bearing the DIGI LINK (II or III) logo can be used with this remote control.

•For system remote control operation, first make the DIGI LINK connections between Sherwood components.

•The numbered buttons on the remote control have different functions in different modes. For details, refer to the “FUNCTION TABLE of the NUMBERED BUTTONS” on the following page.

•In the DIGI LINK III remote control system, if pressing PLAY, etc. on CD player or tape deck, CD or TAPE MONITOR is selected automatically on the receiver without selecting the input source. Then PLAY, etc. starts.

LED LAMP

DEVICE BUTTONS

To operate the desired component with this remote control, first select the corresponding DEVICE button.

DVD

POWER BUTTON

ENTER BUTTON

NUMERIC(1~0) BUTTONS

•For selecting preset stations in tuner mode.

•For selecting a track or a disc in CD mode, etc.

•When selecting a disc, select disc No. (1~5) within 2 sec. after pressing DISC(marked "P.SCAN") button.

		VOLUME UP/DOWN( / ) BUTTONS
VOL.	CH LEVEL	CHANNEL LEVEL UP/DOWN( / ) BUTTONS

OSD CH SEL

ENTER	CURSOR CONTROL(	,	,	,	) BUTTONS
RPT	INTRO
A	B

TITLE
7.1 SURR		RETURN
		AUTO
		DSP
		MODE
		ST
DISC	TEST	CENTER
P.SCAN	TONE	MODE

TUNER CD T1/MON AUX PHONO

VID1 VID2 VID3 VID4 VID5

SYS DISP SLEEP DIRECT IN ROOM2

LIGHT BUTTON

Activates the backlighting of the remote control	HOME THEATER MASTER
	RNC-220
for 7 sec. If any other button is pressed while
the backlighting is on, the remote control will
remain backlit for an additional 7 sec.

10