Sherwood R-863 manual Tuning to preset stations, Scanning preset stations in sequence

ENGLISH

3	Select the desired preset number(1~30)		4	Repeat the above steps		to to
	and press the MEMORY/ENTER button.			memorize other stations.
	TUNING/PRESET	MEMO/ENTER
			MEMORY BACKUP FUNCTION
When using the NUMERIC buttons on the remote			The following items, set before the receiver is turned
control.
			off, are memorized.
Examples)
			INPUT SELECTOR settings
For “3” :			Surround mode settings
	within 2 seconds		Preset stations, etc.
For “15” :
			Note : If the electricity fails or the AC input cord is
For “30” :				disconnected for about 2 weeks, all
The station has now been stored in the memory.				memorized settings will be lost.
When using the NUMERIC buttons, the station is stored
automatically without pressing the MEMORY/ ENTER
button.
A stored frequency is erased from the memory by storing
another frequency in its place.
If “MEMO” goes off, start again from the above step .
Tuning to preset stations			2	Select the desired preset number.
					TUNING/PRESET
1	After selecting the tuner as input source,
	select the preset tuning mode.
			When using the NUMERIC buttons on the remote
	T/P MODE		control.
			Examples)
			For “3”:
			For “15”:		within 2 seconds
					within 2 seconds
			For “30”:		(or	)
Then “PRESET” lights up.			When selecting the desired preset number with the
			NUMERIC buttons, the desired preset station will be
			tuned to automatically without selecting the preset
			tuning mode.

Scanning preset stations in sequence

	The receiver will start scanning the stations in the
	preset sequence and each station is received for 5
DISC	seconds.
	At the desired station, press this button again to
P.SCAN
	stop scanning.

26