Operations
Notes :
Before operating this receiver with the supplied remote control, refer to “Universal Remote Controls” on page 10 for details about operation. Before operating this receiver, first set this unit as desired for optimum performance, by using the OSD menu setting procedures. (For details, refer to “OSD Menu Settings” on page 32.)
LISTENING TO A PROGRAM SOURCE
ENGLISH
Before operation
Enter the standby mode. | POWER |
| ON / OFF |
The STANDBY button lights up in red.
This means that the receiver is not disconnected from the AC mains and a small amount of current is retained to support the memorized contents and operation readiness.
To switch the power off, push the POWER switch again.
Then power is cut off and the STANDBY button goes off.
In the standby mode, turn the power on.
1
STANDBY
ON/STANDBY
or
Each time the STANDBY button on the front panel or the POWER button on the remote control is pressed, the receiver is turned on to enter the operating mode(the STANDBY button lights up in blue) or off to enter the standby mode (the STANDBY button lights up in red).
In the standby mode, if one of the INPUT SELECTOR buttons is pressed, the receiver is turned on automatically and the desired input is selected.
Switch the speakers on. | SPEAKER |
|
2 | ON/OFF |
Then the SPEAKER indicator lights up on the display and sound can be heard from the speakers connected to the speaker terminals.
When using headphones for private listening, press the SPEAKER button again to switch the speakers off.
Select the desired input source.
3
INPUT SELECTOR
AUDIO VIDEO TAPE MON.
TUNER CD T1/MON AUX
or
VID1 VID2 VID3 VID4
Each time the “AUDIO” button is pressed, the input source changes as follows:
TUNER CD AUX (frequency display)
Each time the “VIDEO” button is pressed, the input source changes as follows:
VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4
When the TAPE MONITOR button is set to on so that “TAPE MON” lights up, other inputs can not be heard from the speakers.
To listen to an input source except TAPE MONITOR, be sure to set the TAPE MONITOR button to off.
TAPE MONITOR function
You can connect either a tape deck or a graphic equalizer to the receiver’s TAPE MONITOR jacks.
Only when you listen to the component connected to these jacks, set the TAPE MONITOR button to on.
If you connect a
When selecting the 7.1 CH DIRECT as desired
7.1CH DIRECT
or
DIRECT IN
Depending on the surround back speaker setting, “7.1(,6.1 or 5.1) CH DIRECT” is displayed and the 8(/7/6) separate analog signals from the component connected to this input pass through the tone, volume and bass management(if selected) circuits only and can be heard from your speakers.(In case that the TAPE MONITOR button is set to on, the TAPE MONITOR button is automatically set to off.)
Press the 7.1 CH DIRECT button or select the desired input source to cancel the 7.1 CH direct function.
These analog signals can be heard only. They cannot be recorded.
15
