Sherwood R-863 manual Entering A Setup Code, English

ENGLISH

ENTERING A SETUP CODE

•This remote control can control up to eight different components.

•Before operating audio and video components using the remote control supplied with this receiver, the setup code for each component should be entered.

•Because only the setup codes for CD player and DVD player among Sherwood components are listed in the operating manual of this remote control, when entering a setup code for Sherwood components for system remote control operation, find the corresponding setup code in the “FUNCTION TABLE of the NUMBERED BUTTONS” on page 11 in this operating instructions. For your reference, the setup cord for each Sherwood component such as CD player, tape deck and DVD player(V-756, etc.) is “001” respectively.(However, the setup code for some Sherwood DVD player such as VD-4103, etc. is “057”, “074”, “112”, “114”.) Enter each setup code for CD player and tape

deck doing steps , and		as follows.
1	Turn on the component you want to control.		2	Find the setup code for your component
				referring to “Set-Up Code Table” in the
				operating manual of this remote control.
Example) When entering the setup code for this			Example) The correct setup code for this receiver is
	receiver, turn on this receiver.			“001”.
3	Press the corresponding DEVICE and the		4	Enter the 3 digit setup code aiming the remote control
	MUTE buttons simultaneously.			at the REMOTE SENSOR on the component.
	For receiver or amplifier :		For	"001" :	0	0	1
	For CD player	:
			For	"102" :	1	0	2
	For CABLE	:
			Your component will be turned off when the correct
			setup code is entered.
Then the LED lamp and the corresponding DEVICE			Continue to enter the corresponding codes until your
			component turns off.
button on the remote control light up for 20 seconds.			If the LED lamp and the corresponding DEVICE
			button go off, start from the step again.
5	Press the corresponding DEVICE button to		6	Operate the component using the
	store the setup code.			corresponding function buttons on the remote
				control such as POWER, CH				and
				VOL		buttons, etc.
	For receiver or amplifier :		If any of the buttons do not perform as they should
	For CD player	:	start from step			again to enter the next setup code.
			Note:
			Some audio and video components have separate
			buttons for POWER ON/OFF.
	For CABLE	:	In this case, press the corresponding DEVICE button
			to turn the component ON and press the POWER
			button to turn the component OFF.
			If there is no correct setup code or if the
Then the LED lamp and the corresponding DEVICE			Manufacturer/Brand for your component is not listed
button will flicker twice.			in “Set-Up Code Table” in the operating manual of
			this remote control, please use the “Auto Search
			Method” on page 10 in the operating manual of this
7	Repeat the above steps to for each		remote control.
			Although each setup code is designed to work with
	of your other components.
			many different modes, certain codes may not work with
			some models. (Also, certain codes may only operate
			some of the functions available on a given model.)

14