Sherwood R-863 English, ROOM 2 connections, Connecting Multi-Room System Kit, Connecting Speakers

ENGLISH

■ROOM 2 connections

Another room

Monitor TV

VIDEO IN

VIDEO	Speakers
IN

	A/V receiver
AUDIO IN	or amplifier

• If another A/V receiver or integrated amplifier, etc. is connected to these jacks, you can play a different program source in another room as well as one source in the main room at the same time.(For details, refer to "ROOM 2 SOURCE PLAYBACK" on page 31).

• When the multiroom adaptor is connected to control this unit in another room, the ROOM 2 function is more convenient.

Note:

• To minimize hum or noise, use high quality connection cords in such a way that there is no humming or noise.

■ CONNECTING MULTI-ROOM

SYSTEM KIT

Another room

OUT

Adaptor	IR receiver	Remote control unit
(Multi-room system kit)	(Multi room system kit)

•To control this unit from a remote location, connect this jack to the output of the multi-room adaptor.

For information on the multi-room system kit, contact the Xantech corporation at 1-800-843-5465 or www.xantech.com.

■CONNECTING SPEAKERS

Front right Front left

Surround right

Surround back right

Front center

Surround left

Surround back left

■SWITCHED AC OUTLETS

•These outlets are switched on(power-on mode) and off(standby mode) according to the power control as follows(Maximum total capacity is 1A, 100W):

Standby mode – switched AC outlet off Power-on mode – switched AC outlet on

■AC INLET

Plug the supplied AC input cord into this AC INLET and then into the wall AC outlet.

•Never short circuit the + and - speaker wires.

•Be sure to connect speakers firmly and correctly according to the channel (left and right ) and the polarity ( + and -).

•Be sure to use speakers with the impedance of over 6 Ω.

•Only when enjoying either 6.1 or 7.1 channel surround playback, connect the surround back left speaker only or both of surround

back speakers. Note:

•After installing the speakers, first set the connected speakers to the desired before operating this receiver.(For details, refer to "SETTING THE SPEAKER SETUP" on page 34.)

To a wall AC outlet.

•Do not use an AC input cord other than the one supplied with this unit. The AC input cord supplied is designed for use with this unit and should not be used with any other device.

8