Shindaiwa AHS2510/EVC 10/15-Hour maintenance, Remove and clean or replace the spark plug

Maintenance (continued)

10-Hour maintenance

(more frequently in dusty conditions)

1.Remove the air filter cover by loosen- ing the cover screw(s) and lifting.

2.Remove and inspect the pre-filter. If the pre-filter is torn or otherwise dam- aged, replace it with a new one.

3.Clean the pre-filter with soap and water. Let dry before reinstalling.

4.Inspect the air filter element. If the ele- ment is damaged or distorted, replace it with a new one.

5.Tap filter gently on a hard surface to dis- lodge debris from element or use com- pressed air from the inside to blow debris out and away from the air filter element.

6.Install the air filter element, pre-fil- ter and cover in the reverse order of removal.

10/15-Hour maintenance

Loosen

fasteners

5HPRYHWKHFRYHURIWKHDLU¿OWHU

IMPORTANT!

Direct the air stream at the inside face of the filter only!

3UH¿OWHU

Filter element

&RPSRQHQWVRIDLU¿OWHU

CAUTION!

Never operate the unit if the air cleaner assembly is damaged or missing!

Remove and clean or replace the spark plug.

ŶClean the spark plug. Adjust electrode gap according to the values listed in the ”Specifications” section. If the spark plug must be replaced, use only the type rec- ommended in ”Specifications” or equiva- lent resistor type spark plug of the correct heat range.

CAUTION!

Before removing the spark plug, clean the area around the plug to prevent dirt and debris from getting into the engine’s internal parts.

Gearcase lubrication

ŶLubricate the cutter assembly gearcase by pumping one or two strokes of lithium-base grease into the grease fitting (A) using a lever-type grease gun.

CAUTION!

Over lubricating can cause the gear- case to operate sluggishly and can cause grease to leak out.

Clean the spark

plug and check

the gap at the

electrode.

0,6 - 0.7 mm

5HPRYHDQGLQVSHFWVSDUNSOXJ

A

Lubricate cutter assembly and gearcase	Gearcase
	JUHDVH¿WWLQJ

14