17.5.00 | Anhang.fm | Gigaset3035isdn |
Appendix
17.5.00 | Anhang.fm | Gigaset3035isdn |
Appendix
Press the keys in the specified order
Press the keys in the specified order
HWLQJ÷÷÷
<$6\VFFHVVWHP&RGH÷÷÷÷÷VHWWLQJV =P
<6DYHHQWU\÷÷÷=
#and $
Operating at telephone systems
The following device parameters should be set if you want to operate your base station telephone downstream of a telephone system:
1.Set the appropriate dialling procedure for operation at your telephone system
Keypad protocol, ➔ page 134 or
Dialling * and #, ➔ page 135
2.Set the prefix code, ➔ page 136
3.Activate the “Call transfer” function,
➔page 137
For information on using the functions enquiry call, tog- gle and switching back to the initial subscriber, see chapter “Enquiry call from an external call to an external subscriber” for the base station telephone, Comfort hand- set and Classic handset on ➔ page 59.
Setting the prefix code
If you are using your base station telephone on a tele- phone system, then you have to dial a prefix code (ex- change code) to access the public telephone network. The operating instructions for the telephone system will ex- plain the prefix code.
The base station telephone automatically stores a set pre- fix code with the call numbers received and transferred. This enables you to dial the call numbers directly from the caller list, directory or redial list.
Call the menu.
Select and confirm.
Enter the prefix code.
Open the supplementary menu.
Save the entry.
The phone is in standby.
HWLQJ÷÷÷÷÷÷÷÷
<&DO'LDO6SHF\VOWHP7SRSHUWLHVUIXDQVIHU÷÷÷VHWQJVFWLRQ=
=
#and $
®In the case of new entries in the directory, call re- strictions, emergency numbers and hot key num- bers, the prefix code must be stored manually in front of each call number.
®Not all telephone systems support the functions in the same way as the main telephone station. Check with your provider whether all functions are identi- cal to those of the main telephone station.
If you wish to use the switching function of the base station telephone or handset at a telephone system, you must use the “Consultation with ex- ternal subscriber” function, see page 59.
Activating automatic explicit call transfer (ECT)
This is necessary when the base station is operated at cer- tain ISDN telephone systems. For example, in the case of an external call, the factory settings do not allow for the first called party and the second party to be connected when you replace the handset. If you wish to switch this function:
Select and confirm.
The display is highlighted if this function is active.
To switch the setting:
Activate/deactivate the function.
The phone is in standby.
®If the “Transfer Call” option is highlighted, the sta- tion automatically switches to “External Enquiry Call”.
136
137
