Siemens 3035isdn Cost conversions in the exchange, Setting the price per unit, Example

Open the supplementary menu. Select and confirm.

Before you make the change, you will be asked “Del. a/c alloc. for new a/cs?“. Any previously set calculations are deleted.

Confirm the change.

17.5.00 Kosten.fm Gigaset3035isdn A31008-G3035-B101-6-7619 Korrektur: 0

Cost-effective telephoning

Press the keys in the specified order

17.5.00 Kosten.fm Gigaset3035isdn A31008-G3035-B101-6-7619 Korrektur: 0

Cost-effective telephoning

Press the keys in the specified order

	Setting the price per unit
	Before your phone can calculate the costs for each call un-
	der the “UnitsCentr.Off.” setting, you must first set the
	￿currency and the price per unit.
HWLQJ÷÷÷÷÷÷	Call the menu.
&R6\VHPVWVGXUD￿VHWQJVWLRQ÷P	Select and confirm.

KQGORIFRVWV÷	Enter the base PIN (factory setting 0000) and confirm.
	To display decimal places.
<5DWH￿￿￿￿￿￿￿÷÷÷÷÷	or
P=to display figures without decimal places.
	Enter the cost per unit and the currency and conf rm.
	Example			￿￿￿
	Input with decimal places:
	Example	3_cdBQdU*
	Input with no decimal places:		￿!"	￿￿￿
	Enter the currency. Currency	3ebbU^Si*
	names (e.g. DEM) can be en-		&	´
	tered using the digit keys, while
	currency symbols (e.g. Euro)
	can be entered using the supple-
	mentary menu.

6DYH￿HQWU\÷÷÷÷÷÷=9

￿<(6￿￿÷

#and $ The phone is in standby.

<

￿

HWLQJ÷÷÷÷÷÷

6R\VHPVWV￿GXUD￿HWQJVWLRQ÷P

&DOO￿GLVSOD\÷÷÷÷

Type of display =

#and $

Selecting the type of display

This setting only applies to the information displayed dur- ing a call. You can choose between

●duration of call,

●units,

●cost of the current call (call charges),

●cost of last call.

Call the menu.

Select and confirm.

Enter the base PIN (factory setting 0000) and confirm.

If the item is highlighted, the display is already set.

Select the type of display required.

The phone is in standby.

®If you want the costs displayed, you must first enter the price per unit.

Cost conversions in the exchange

Your provider converts from “transmission of units” to “transmission of individual call charges”.The following message then appears on your base station telephone dis- play: “Please change charge units: CostsCentr.Off.“ and a beep is emitted to signal an error.

The current counts are stored and remain unchanged dur- ing subsequent calls. Counts only continue after conver- sion has taken place.

The display will not show any monetary amounts until the “CostsCentr.Off.“ accounting method is set, see also page 49.

®The base station telephone does not always receive the information when costs are converted. Please remember this when comparing the telephone costs you have calculated with the bill from your provider.

50

51