Safety Instructions Issue A1
MICROMASTER 410 Operating Instructions
86SE6400-5EA00-0BP0
Transport & Storage
WARNING
♦ Correct transport, storage, erection and mounting, as well as careful
operation and maintenance are essential for proper and safe opera tion of the
equipment.
CAUTION
♦ Protect the inverter against physical shocks and vibration duri ng transport and
storage. Also be sure to protect it against water (rainfall) and exces sive
temperatures (see table on page 19).
Commissioning
WARNINGS
♦ Work on the device/system by unqualified personnel or failure to comply with
warnings can result in severe personal injury or serious damage to material.
Only suitably qualified personnel trained in the setup, install ation,
commissioning and operation of the product should carry out work on the
device/system.
♦ Only permanently-wired input power connections are allowed. This equipment
must be grounded (IEC 536 Class 1, NEC and other applicable standards).
♦ If a Residual Current-operated protective Device (RCD) is to be used, it must
be an RCD type B.
♦ The following terminals can carry dangerous voltages even if the inverter is
inoperative:
- the power supply terminals L and N.
- the motor terminals U, V, W and the terminals DC+ and DC-.
♦ This equipment must not be used as an ‘emergency stop mechanism ’ (see
EN 60204, 9.2.5.4)
CAUTION
The connection of power, motor and control cables to the inverter m ust be carried
out as shown in Figure 2-10 on page 30, to prevent inductive and capacit ive
interference from affecting the correct functioning of the inverter.