Raven 1x
D[method][d.d.d.d][/ppppp] or D[method][@name][/ ppppp]
Dial a connection to a remote IP and Port using method.
Cannot be configured in AceManager.
•method=P : Establish a UDP connection
•method=T : Establish a TCP connection
•method=N : Establish a Telnet connection
•d.d.d.d= IP address to contact
•ppppp= port to contact
Examples:
ATD - Dial (establish) default connection.
ATDP192.168.13.31/2332 - Dial (establish) UDP session to 192.168.13.31, at port 2332.
To end the connection, issue the +++ escape sequence or drop the DTR line (if Ignore DTR S211=0 or &D2). The default connection is set in S53.
If the method, IP address, or port is omitted, the values from S53 are used. If a telnet connection is requested (N) and the port is not supplied, port 23 will be used instead of the value from S53.
If a domain name is specified, the ʹ@ʹ symbol can be used to explicitly indicate the start of the name. For example, if ATDPHONY is issued, this will be interpreted as dial a UDP connection to “HONY”. To dial using the default method to host “PHONY”, one would issue ATD@PHONY.
Several special dialing numbers exist to make it easy to establish a PPP or SLIP connection with the modem. ATD#19788 or ATDT#19788 will establish a PPP connection (see \APPP) and ATDT#7547 will establish a SLIP connection (see \ASLIP).
Tip: The source port of the session is the Device Port (set by S110 or *DPORT).
DS=n
Allows a PPP connection to be initiated on the host port.
•n=2 : Initiates the PPP connection.
Cannot be configured in AceManager.
Hn
Hang‐Up Command.
•n=1 : Hang‐up
|
|
|
|
|
|
|
98 |
|
|
|
|
| 20070914 |
|
|
|
