Powerstatecontrols
Thesecommands place theprojector in and out of Standbymode and requestt heprojector’s current
powerstate.The projector’spowerstate determineswhether certaincommands areavailable at that
time.These settings are available evenw henthe projector is in Standby mode.
Command Response
on powerstate=[field]
off powerstate=[field]
offnow powerstate=[field]
getpowerstate powerstate=[field]
Thefollowing table describest hepowerstate commands:
Command Description
on Turnson the projector.
off Startst hes hutdownprocess. A dialog box appearswit h the
message,“Press Power Button to Turn off Projector.”Y oumust send
asecond Off commandwit hin10 seconds to put the projector into
Standbymode.
offnow Shutsdown the projector immediately.Y oucan’t delay or cancel this
command.
getpowerstate Indicatesthe projector’s currentpowerstate.
Thefollowing table describest hepowerstate fields:
Field Description
Powering Theprojectoris turningon.
On Theprojector is on.
Cooling Theprojectoris cooling.
Confirmoff Confirm off is a non-selectablepowerstatethat is returnedduring
stageone of the two-button offsequence.
Idle Theprojectoris off but still receiving power(Standby mode).
Sourceselectioncontrols
Thesecommands switch inputs ources.The sourcet ypedetermines whichc ommandscan be
accepted.
Command Response Available whenin Standby
mode
getinput input=[field] Yes
setinput [field] input=[field] No
AP P E N D I X A
Remotelymanaging your intera ctivewhiteboar d system
58