SmartBridges sB3415-01, sB3415-02 manual Changing from Bridge to Router/NAT Mode sB3415-03 Only

i n t e l l i g e n t w i r e l e s s p l a t f o r m

3.Click on Save to convert the unit to Bridge mode.

4.The Bridge Mode on sB3415 can be configured to operate in WDS and non-WDS modes. For all the different modes configuration in Bridge Mode, refer to Section 2.9.

Figure 2-9 Changing Router/NAT Mode to Bridge Mode (sB3415-03 only)

2.8. Changing from Bridge to Router/NAT Mode (sB3415-03 Only)

This section is only valid for the sB3415-03 model. Follow the steps below to change the airClient TOTAL from the Bridge mode to Router/NAT mode.:

1.From the navigation menu bar, click on Tools System Configuration. The Operation Mode screen will appear as shown below.

2.Under the Current Operational Mode settings, choose Router or NAT option.

3.Click on Save to reboot the unit and to convert the unit to Router/NAT mode.

4.To configure the Wired parameters, see Section 2.10.1

5.To configure the WLAN IP and Radio parameters, like SSID, see Section 2.10.2

airClient™ TOTAL 3415 User Guide Page 23 of 75