i n t e l l i g e n t w i r e l e s s

p l a t f o r m

Figure 2-11 airClient TOTAL WDS Bridge Mode Configuration (sB3415-03 Only)

LAN Settings

This section outlines the procedures for changing the IP settings for bridge mode –

1.From the navigation menu bar, click on Home LAN Settings to change Ethernet/wired side parameters. The LAN Settings screen will appear as shown below in Fig 2-12.

2.Enter the System Name of the unit, if needed.

3.Enter the IP address and Subnet mask to set the LAN IP address and subnet mask, and any Gateway Address if required. Assign the unit a unique IP Address in the designated IP subnet.

4.Click on Save to save the changes. The settings will be applied after the reboot.

airClient™ TOTAL 3415 User Guide

Page 26 of 75

 

Page 26
Image 26
SmartBridges sB3415-01, sB3415-02, sB3415-03 manual LAN Settings