i n t e l l i g e n t w i r e l e s s

p l a t f o r m

Figure 2-28 Disable DHCP and DHCP Relay

2.10.4.DHCP Relay Configuration

If the user has a DHCP Server, the airClient TOTAL Router can be configured as a DHCP Relay agent of the DHCP Server for IP address assignment.

Follow the steps below to configure the airClient TOTAL unit as a DHCP Relay Agent:

1.From the Navigation menu bar, click on Networking DHCP Server to access the DHCP configuration page.

2.Click on Enable DHCP Relay to choose DHCP Relay mode.

3.Enter a valid DHCP Server IP.

4.Click on Save button to apply the settings and to start the DHCP relay agent.

Note: The system will validate the input parameters and notify users of invalid entry.

The DHCP Server IP will be in the same network segment as the device wireless Radio IP address.

The DHCP Server needs to be configured to serve IP range of the wired side Ethernet IP.

The DHCP Relay Agent is only available to hosts connected to the same LAN segment as the device wired-side Ethernet port.

Figure 2-29 airClient TOTAL DHCP Relay Configuration

airClient™ TOTAL 3415 User Guide

Page 44 of 75

 

Page 44
Image 44
SmartBridges sB3415-01, sB3415-02, sB3415-03 manual Dhcp Relay Configuration, Disable Dhcp and Dhcp Relay