i n t e l l i g e n t w i r e l e s s | p l a t f o r m |
Figure 2-18 airClient TOTAL Transparent Bridging Configuration (sB3415-03 Only)
LAN Settings
This section outlines the procedures for changing the IP settings for bridge mode. These settings are the same in all possible bridge modes –
1.From the navigation menu bar, click on Home LAN Settings to change IP address and mask of the unit in bridge mode. The LAN Settings screen will appear as shown below in Fig
2.Enter the System Name of the unit, if needed.
3.Enter the IP address and Subnet mask to set the IP address and subnet mask, and any Gateway Address if required. Assign the unit a unique IP Address in the designated IP subnet.
4.Click on Save to save the changes. The settings will be applied after the reboot.
airClient™ TOTAL 3415 User Guide | Page 33 of 75 |
|
