Sony CCD-TRV101E operating instructions Trouble check, English, Power, Operation

English

Trouble check

If you run into any problem using the camcorder, use the following table to troubleshoot the problem. Should the difficulty persist, disconnect the power source and contact your Sony dealer or local authorized Sony service facility.

Camcorder

Power

Symptom	Cause and/or corrective actions
The power is not on.	• The battery pack is not installed.
	m Install the battery pack. (p. 10)
	• The battery is dead.
	m Use a charged battery pack. (p. 7)
	• The AC power adaptor is not connected to mains.
	m Connect the AC power adaptor to mains. (p. 29)
	• If the power is still not on after you tried the corrective actions
	above, press the RESET button on the back of the battery
	compartment lid using a sharp-pointed object. (If you press
	the RESET button, all the settings including the date and time
	return to the default.)
The power goes off.	• While being operated in CAMERA mode, the camcorder has
	been in Standby mode for more than 5 minutes.
	m Set the POWER switch to OFF, then to CAMERA. (p. 12)
	• The battery is dead.
	m Use a charged battery pack. (p. 7)
	• If VF PW-SAVE is set to ON in the menu system, the picture
	disappears automatically when you turn your face away from
	the viewfinder.
	m Bring your face close to the viewfinder within 1 cm (1/2
	inch). Or set VF PW-SAVE to OFF in the menu system. (p.
	32)
The battery pack is quickly discharged.	• The ambient temperature is too low. (p. 86)
	• The battery pack has not been charged fully.
	m Charge the battery pack again. (p. 7)
	• The battery pack is completely dead, and cannot be recharged.
	m Use another battery pack. (p. 29)
	• The camcorder does not operate when using a battery that is
	not an InfoLITHIUM battery pack.
	m Use an InfoLITHIUM battery pack. (p. 7)

Additional information / Información adicional

Operation

Symptom	Cause and/or corrective actions
START/STOP does not operate.	•	The tape is stuck to the drum.
		m Eject the tape. (p. 11)
	•	The tape has run out.
		m Rewind the tape or use a new one. (p. 23)
	• The POWER switch is set to PLAYER.
		m Set it to CAMERA. (p. 12)
	•	The tab on the cassette is out (red).
		m Use a new tape or slide the tab. (p. 11)

The cassette cannot be removed from the holder.

•The battery is dead.

m Use a charged battery pack or the AC power adaptor. (p. 7, 29)

Continued to the next page

95

CCD-TRV101E.3-856-814-11 (E,S)