For example, when the 
button is pressed while 
is displayed, playback of the next track starts. Music sensor function may not be able to detect tracks under the following conditions:
•Blanks of less than 4 seconds between tracks
•Noisy blanks
•Long passages of
•Low overall recording levels
|
|
|
|
| TAPE PLAYBACK (cont.) | pg. 12 |
|
|
|
|
|
CONTINUOUS PLAY
After playback on one deck finishes, the tape in other deck will start to play without interruption.
1 Insert tapes into deck 1 and deck 2.
2 Press the TAPE/DECK1/2 button to select the deck to be played back first.
3 Press the REV MODE button to select 
.
4 Press the 
button to start playback.
Playback continues until the Ñbutton is pressed.
About cassette tapes
•To prevent accidental erasure, break off the plastic tabs on the cassette tape after recording with a screwdriver or other pointed tool.
To record on the tape again, cover the tab openings with adhesive tape, etc. (On Type II tapes, take care not to cover the Type II tape detection slot.)
•
•Take up any slack in the tape with a pencil or similar tool before use. Slack tape may break or jam in the
