Sony DCR-TRV16, DCR-TRV25, DCR-TRV27 - page 79

Dubbing only desired scenes - Digital program editing (on tapes)
To edit using the VCR, send the control signal by infrared rays to the remote sensor on
the VCR.
When you connect using the A/V connecting cable, follow the procedure below, (1) to
(4), to send the control signal correctly.
(1) Set the IR SETUP code
(!) Set the POWER switch to VCR oi1your camcorder.
(g) Turn the power of the connected VCR on, then set the input selector to LINE.
When you connect a video camera recorder, set its power switch to VCR/VTR.
_) Press MENU. Select VIDEO EDIT in [] with the SEL/PUSH EXEC dial
(p. 184).
(if) Turn the SEL/PUSH EXEC dial to select TAPE, then press the dial. (except
DCR-TRV16)
(_) Turn the SEL/PUSH EXEC dial to select EDIT SET, then press the dial.
(_) Turn the SEL/PUSH EXEC dial to select CONTROL, then press the dial.
(_) Turn the SEL/PUSH EXEC dial to select 1R, then press the dial.
(_) Turn the SEL/PUSH EXEC dial to select IR SETUP, then select IR SETUP code
of your VCR, then press the dial. Check the code in "About IR SETUP code."
(p.80)
3
4
5
MEN
EDITSET
6
8
79