Sony DCR-VX2000 Precautions, Camcorder operation, On handling tapes, Camcorder care

Maintenance information and precautions

Charging the vanadium-lithium battery in your camcorder

Your camcorder is supplied with a vanadium-lithium battery installed so as to retain the date and time, etc., regardless of the setting of the POWER switch. The vanadium- lithium battery is always charged as long as you are using your camcorder. The battery, however, will get discharged gradually if you do not use your camcorder. It will be completely discharged in about four months if you do not use your camcorder at all. Even if the vanadium-lithium battery is not charged, it will not affect the camcorder operation. To retain the date and time, etc., charge the battery if the battery is discharged.

Charging the vanadium-lithium battery:

•Connect your camcorder to house current using the AC power adaptor supplied with your camcorder, and leave your camcorder with the POWER switch turned off for more than 24 hours.

•Or install the fully charged battery pack in your camcorder, and leave your camcorder with the POWER switch turned off for more than 24 hours.

Precautions

Camcorder operation

•Operate your camcorder on 7.2 V (battery pack) or 8.4 V (AC power adaptor). •For DC or AC operation, use the accessories recommended in this operating

instructions.

•If any solid object or liquid get inside the casing, unplug your camcorder and have it checked by a Sony dealer before operating it any further.

•Avoid rough handling or mechanical shock. Be particularly careful of the lens. •Keep the POWER switch set to OFF (CHG) when you are not using your camcorder. •Do not wrap your camcorder with a towel, for example, and operate it. Doing so

might cause heat to build up inside.

•Keep your camcorder away from strong magnetic fields or mechanical vibration. Noise may appear on the image.

•Do not touch the LCD screen with a sharp-pointed object.

•If your camcorder is used in a cold place, a residual image may appear on the LCD screen. This is not a malfunction.

•While using your camcorder, the back of the LCD screen may heat up. This is not a malfunction.

On handling tapes

•Do not insert anything into the small holes on the rear of the cassette. These holes are used to sense the type and thickness of the tape and if the recording tab is in or out.

•Do not open the tape protect cover or touch the tape.

•Avoid touching or damaging the terminals. To remove dust, clean the terminals with a soft cloth.

Camcorder care

•Remove the tape, and periodically turn on the power, operate the CAMERA and VCR sections and play back a tape for about three minutes when your camcorder is not to be used for a long time.

•Clean the lens with a soft brush to remove dust. If there are fingerprints on the lens, remove them with a soft cloth.

•Clean the camcorder body with a dry soft cloth, or a soft cloth lightly moistened with a mild detergent solution. Do not use any type of solvent which may damage the

158 finish.