Sony DCR-VX2000 Audio dubbing, If you make all the connections, To add new sound more precisely

Audio dubbing

Notes

•New sound cannot be recorded on a tape already recorded in the 16-bit mode (p. 111). •New sound cannot be recorded on a tape already recorded in the LP mode.

•You cannot add audio with the DV IN/OUT jack.

If you make all the connections

The audio input to be recorded will take precedence over others in the following order. •MIC (PLUG IN POWER) jack

•Intelligent accessory shoe •AUDIO L/R jacks •Built-in microphone

If an i.LINK cable (DV connecting cable) (not supplied) is connected to your camcorder

You cannot add sound to a recorded tape.

If you set the write-protect tab of the tape to lock

You cannot record on the tape. Slide the write-protect tab to release the write protection.

We recommend that you add new sound on a tape recorded with your camcorder

If you add new sound on a tape recorded with another camcorder (including an other DCR-VX2000), the sound quality may deteriorate.

To add new sound more precisely

Press ZERO SET MEMORY on the Remote Commander at the point where you want to stop recording later in playback mode. Then, follow the procedure from step 3. Recording automatically stops at the point where ZERO SET MEMORY was pressed.

On blank portions

You cannot add an audio.

You can adjust the recording level manually using the recording adjustment display in the following cases:

–Dubbing with an optional external microphone or audio equipment through the MIC jack

–Dubbing with an optional external microphone installed into the intelligent accessory shoe.

–Dubbing with the internal microphone

96