Inserting a scene from a VCR – Insert editing
You can insert a new scene from a VCR onto your originally recorded tape by specifying the insert start and end points. Use the Remote Commander for this operation. Connections are the same as on page 73 or 86.
Insert a cassette containing the desired scene into the VCR.
[a]
[A]
[b][c]
[B]
[C]
[A]: The tape that contains the scene to be superimposed
[B]: The tape to be edited
[C]: The tape after editing
(1) Set the POWER switch to VCR on your camcorder.
(2) On the VCR, locate a point just before the insert start point [a], then press X to set the VCR to the playback pause mode.
(3) On your camcorder, locate the insert end point [c] by pressing m or M. Then press X to set it to the playback pause mode.
(4) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET MEMORY indicator flashes and the end point of the insert is stored in memory. The tape counter shows “0:00:00.” If the tape counter does not appear, press DISPLAY.
(5) On your camcorder, locate the insert start point [b] by pressing m, then press
zREC and the button on its right simultaneously, then immediately press X on your camcorder.
(6) First press X on the VCR, and after a few seconds press X on your camcorder to start inserting the new scene.
Inserting automatically stops near the zero point on the tape counter. Your camcorder automatically returns to the recording pause mode.
4 | 0:00:00 |
| |
ZERO SET | ZERO SET |
MEMORY | MEMORY |
|
|
Editing
5 REC | PAUSE |
91
