This selection determines the way in which monitoring will be carried out during recording.
CONFI switch
Selecting the monitoring mode for recording
Use the CONFI switch on the connector panel to select the monitored signal.
•To monitor the simultaneous playback of the recorded video and audio signals from the confidence heads, using a video monitor or other equipment connected to the VIDEO OUT connector, set the CONFI switch to the ON position.
•To carry out error detection by means of ECC without direct monitoring of the recorded signals, set the CONFI switch to the ECC position. In this case the monitor output during recording is an
•To carry out no direct monitoring of the recorded signals, and only RF envelope monitoring, set the CONFI switch to the OFF position.
•The OFF setting results in the lowest power consumption, and the ON setting the highest. When using the unit with a battery pack, set the CONFI switch to the ECC or OFF position.
This section describes how to set user bit values, time code values and the real time.
Open the lid covering the time code setting controls as shown in the following figure.
Pull the projecting lug forward.
Opening the lid covering the time code setting controls
Setting a constant user bit value
The user bit values recorded on the time code track provide for eight hexadecimal digits, which can be used to hold the date, time, scene number or other information.
1
2,5 4 3
Setting the user bit value
1 Set the DISPLAY switch by the status indication panel to
2 Set the
3 Set the REAL TIME record/set switch to REC ON or OFF.
Recording 4 Chapter
Chapter 4 Recording