Recording 4 Chapter

4-2 Procedures for Recording

Recording the input signals from the VIDEO IN connector or SDI IN connector

1 Switch the POWER switch on, and load a cassette.

2 Hold down the REC button, and press the PLAY button.

Recording starts, except that if there is no video signal input to the VIDEO IN connector or SDI IN connector recording does not start.

3 To end recording, press the STOP button.

Pausing recording

Press the PAUSE button. To restart recording, press the PAUSE button once more.

If the unit remains in the paused state for thirty minutes, the paused state is automatically ended to protect the tape, and the state is the same as after pressing the STOP button.

When the tape does not move

If no video signal is input, or if there is an input but the level is extremely low, the tape will not move. Check the video input level, referring to the section “Displaying and adjusting the video input levels” (page 4-3).

4-14Chapter 4 Recording