2-2-1 Audio Connectors and Controls

1 CONFI switch

 

 

 

2 CUE REC switch

 

 

 

3 CH-3/4 OUT switch

 

6 +48 V

switches (DVW-250P only)

4 MONITOR

 

 

7 CAMERA/LINE switches

SELECT switches

5 PHONE

 

 

8 Audio input level switches

LEVEL control knob

 

9 AUDIO IN connectors

0 AUDIO OUT connectors !¡ EARPHONE jack

!™ HEADPHONES jack

Audio connectors and controls

Parts of Function and Location 2 Chapter

1CONFI (confidence) switch

This selects the mode for monitoring during recording. Note that this switch applies to both video and audio.

ON: Monitor the simultaneous playback of the recorded signals from the confidence heads.

ECC (Error Correcting Codes): Monitor the input signals unchanged (in E-E mode). If a serious error is detected while recording the signals, a warning indication is given.

OFF: Monitor the input signals unchanged (in E-E mode). The RF envelope is monitored during recording, and if a fault occurs a warning indication is given.

The ON setting results in the highest power consumption, and the OFF setting the lowest. When using the unit with a battery pack, set the CONFI switch to the ECC or OFF position.

2CUE REC (record) switch

It is possible to mix the analog audio input signals and record them on the analog cue track on the tape. This switch determines whether or not to record on the cue track during normal recording. When this switch is in the ON position, channels 1 to 4 of the analog audio input are mixed and recorded on the cue track.

When using the CUE DUB button on the front panel (see page 2-3)for cue dubbing, the audio signal is

recorded on the cue track regardless of the position of this switch.

3CH-3/4 (channels 3 and 4) OUT switch

This selects the output from channels 3 and 4 of the AUDIO OUT connectors.

MON: the signals selected by the MONITOR SELECT switches

LINE: the signals of audio channels 3 and 4

4MONITOR SELECT switches

These select the audio signals which can be monitored using the EARPHONE jack, HEADPHONES jack, and RFU OUT connector. When the CH-3/4 OUT switch is in the MON position, these switches also select the audio output from channels 3 and 4 of the AUDIO OUT connectors.

CUE: the audio from the cue track

DA: Use the channels selected by the switch to the right.

1/2: audio channels 1 and 2

3/4: audio channels 3 and 4

MIX: A mix of those of the four channels for which the corresponding switches below are in the ON position.

Chapter 2 Location and Function of Parts

2-11