General
How to restore Video settings to _actol T settings
How to restore Audio settings to _actory settings
Cannot cycle through the other
video equipment connected to the TV
Cannot operate menu
Lost password
LED on the display unit isiii
The signal fi'om a selected
iiINK device is not being displayed
Press | on | the | remote | control | while | in | the | Video menu (see page 102). | |
Press | on | the | remote | control | while | in | the | Audio menu (see page 106)• | |
Be sure the |
|
| option is | not set | to |
| (seepage | 116). | |
Ifa menu option appears in gray, this indicates that the menu option is not available.
In the password screen (see page 112), enter the following master password:
•The master password clears your previous password; it cannot be used to
temporarily unblock channels•
The iiINK STANDBY LED blinks when the signal froln an iiINK device is being shown.
The POWER STANDBY LED (see page i8i lights up when the TV is iumed on.
If the LED blinks continuously, this may indicate the TV needs a service.
The TIMER LED (see page 18) indicates that the timer is set. When the timer is set, this LED will remain lit even when the TV is turned off.
If the STANDBY LED blinks, disconnect the AC power cord and leave the TV for three minutes to check that it stops blinking. If the LED does not stop blinking, contact qualified Sony personnel•
If you have several i.LINK devices connected and operating at once, the TV may not be able to display the signal fi'om the selected device. Turn the other i.LINK
devices oil, and reselect the desired iilNK device.
