SETUP
SETUP
Other Info
General
Problem | Possible Remedies | |
How to reset TV to | ❏ | Turn on the TV. While holding down the RESET button on the remote |
factory settings |
| control, press the POWER button on the TV. (The TV will turn itself off, then |
|
| back on again.) Release the RESET button. |
|
| |
How to restore Video settings ❏ | Press the RESET button on the remote control while in the Video Menu (see | |
to factory settings |
| page 92). |
How to restore Audio | ❏ | Press the RESET button on the remote control while in the Audio Menu (see |
settings to factory settings |
| page 94). |
Cannot cycle through the | ❏ | Be sure the Video Label option is not set to Skip (see page 104). |
other video equipment |
|
|
connected to the TV |
|
|
Cannot operate Menu | ❏ | If a menu option appears in gray, this indicates that the TV is in a state in |
|
| which the menu option is not available. |
|
|
|
Lost password | ❏ | In the password screen (see page 100), enter the following master |
|
| password: 4357. The master password clears your previous password; it |
|
| cannot be used to temporarily unblock channels. |
LED on front panel is lit | ❏ | The STAND BY LED (see page 15) blinks when the TV is turned on, then |
|
| shuts off when the picture is displayed. If the LED blinks continuously, this |
|
| may indicate the TV needs service. |
| ❏ | The TIMER LED (see page 15) indicates that the timer is set. When the |
|
| timer is set, this LED will remain lit even when the TV is turned off. |
| ❏ | The i.LINK STANDBY LED blinks when the signal from an i.LINK device |
|
| is being shown. |
The signal from a selected | ❏ | If you have several i.LINK devices connected and operating at once, the TV |
i.LINK device is not being |
| may not be able to display the signal from the selected device. Turn the |
displayed |
| other i.LINK devices off, and reselect the desired i.LINK device. |
|
|
|
