32
SETUP SETUP SETUPSETUP SetupSETUP

Satellite Receiver

and VCR

To connect a satellite receiver and VCR
1Connect the satellite antenna cable to the satellite receiver’s
satellite input jack.
2Connect the CATV cable to the VCR’s VHF/UHF input jack.
3Use a coaxial cable to connect the VCR’s VHF/UHF output jack
to the TV’s CABLE jac k.
4Use an A/V cable to connect the satellite receiver’s A/V output
jacks to the VCR’s A/V input jacks.
5Use an A/V cable to connect the VCR’s A/V output jacks to the
TV’s A/V input jacks.
6Run the Auto Setup program, as described in “Setting Up the
Channel List” on page 41.
Notes on Using This Connection
Using
S VIDEO jacks?
See page23.
To Do This ... Do This ...
Watch the satellite receiver Press TV/VIDEO repeatedly to select the VCR input (VIDEO 1 in the
illustration).
The VCR may need to be turned on and set to the satellite receiver input.
Watch the VCR Press TV/VIDEO repeatedly to select the input to which the VCR is connected
(VIDEO 1 in the illustration).
Set up the TV remote control
to operate the satellite
receiver or VCR
If you have a non-Sony VCR or satellite receiver, you must program the
remote control. See “Programming the Remote Control” on pages 49-50.
Activate the TV remote
control to operate the satellite
receiver or VCR
For the satellite receiver, press SAT/CABLE FUNCTION. For the VCR, open the
outside cover, as shown on page 48. T hen set the A/V slide switch to the
position you programmed for the VCR.
Control satellite receiver and
VCR functions with the TV
remote control
See “Operating a Satellite Receiver” on page51 and “Operating a VCR” on
page 51.
Label video inputs to easily
identify equipment connected
to the TV
See the instructions for setting up Video Labels on pages 103-104.
AX1 PJ.book Page 32 Wednesday, April 30, 2003 2:13 PM