Never block the slots and openings by placing the set on a bed, sofa, rug or other similar surface.

Never place the set in a confined space, such as a bookcase or built-in cabinet, unless proper ventilation is provided.

Refer to section 54-300 of Canadian Electrical Code for

Antenna Grounding.

---%-<0___

' Antenna lead-in wire

Do not place the set near or over a radiator or heat register, or where it is exposed to direct sunlight.

NEC: National Electrical Code

(NEC Section 810-20)

_ Antenna lead-in wire Grounding conductors (NEC section 810-21)

Ground clamps

Power service grounding electrode system (NEC Art 250 Part H)

Do not allow anything to rest on or roll over the power cord, and do not place the set where the power cord is subject to wear or abuse.

If an outdoor antenna is installed, follow the precautions below. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits.

WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL.

Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges.

Section 810 of the National Electrical Code (NEC) in USA and Section 54 of the Canadian Electrical Code in Canada provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

For added protection for this television receiver during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna. This will prevent damage to the receiver due to lightning and power-line surges.

_@':V: :7@

Unplug the set from the wall outlet and refer servicing to qualified service personnel under the following conditions:

When the power cord or

 

 

 

plug is damaged or frayed.

Fp,4"C_po_ _Atlr

 

 

If liquid has been spilled into

C. LIN_-

CRA_#ED

_L _r

 

 

 

the set.

 

 

 

 

If the set has been exposed

i

It

,

 

 

 

 

 

to rain or water.

 

 

 

If the set has been subject to

 

 

 

excessive

shock by being

 

 

 

dropped, or the cabinet has

 

 

 

been damaged.

 

 

 

If the set does not operate

 

 

 

normally

when following the

 

 

 

operating

instructions.

 

 

 

Adjust only those controls

 

 

 

that arc specified in the

 

 

 

operating

instructions.

 

 

 

Improper

adjustment of

 

 

 

other controls may result in

damage and will often require extensive work by a qualified technician to restore the set to normal operation.

When the set exhibits a distinct change in performance, it indicates a need for service.

6

Page 6
Image 6
Sony KFO42WE610, KFO60WE610, KFO50WE610 operating instructions If liquid has been spilled into