OFF: No zebra pattern is displayed.

MOMENT: The zebra pattern is displayed and stays for 5 to 6 seconds. The zebra pattern is factory set to indicate picture areas where the

video level is approximately 70%. The setup menu can be used to 2 specify that areas where the video level is 100% and above are to be displayed at the same time.

For information about how to set the zebra pattern is to be displayed to indicate areas of 100% or more, see Section 4-7-5 “Setting the Viewfinder” (page 4-51).

7TALLY switch

This switch controls the TALLY indicator, setting its brightness (HIGH or LOW) or turning it off.

HIGH: The TALLY indicator gets brighter.

OFF: The TALLY indicator does not operate.

LOW: The TALLY indicator gets dimmer.

8Diopter adjustment ring

Use this ring to adjust the viewfinder image for your vision.

Chapter 2 Locations and Functions of Parts and Controls 2-15