8GOOD SHOT REC INHI (shot mark recording inhibit) indicator
This indicator is on or off according to the combination of the F5 (RECINH) setting on function menu page 4 and the record inhibit plug on the cassette, as shown in the following table. When this indicator is on, writing shot marks on tape is prohibited.
GOOD SHOT REC INHI indicator indications
RECINH setting | State of the record | GOOD SHOT |
| inhibit plug on the | REC INHI |
| cassette | indicator state |
ON | Record inhibit/permit | Lit |
|
|
|
OFF | Record inhibit | Lit |
|
|
|
| Record permit | Off |
|
|
|
9Tape transport control section
1PREROLL button
PREROLL
STANDBY
2 STANDBY button
REW | PLAY | F FWD | STOP |
|
|
3 STOP button
4 F FWD button
5PLAY button
6SERVO indicator
7REW button
1PREROLL button
Press this button to cue up to the preroll point (before the IN point by the time set as the preroll time) on the tape. You can change or select the preroll time and the state of the unit at the end of preroll (“stop mode” 1) or still playback mode) using setup menu item 001 or 401.
Cuing up to DMC playback control points
Hold down the STUNT IN, STUNT OUT, PLAY IN, or PLAY OUT button while pressing this button to cue up to the corresponding DMC playback control point.
2STANDBY button
When a cassette is inserted and this button is off, to put the unit in standby mode, press the button, turning it on.
In standby mode, the drum is rotating and the tape is in contact with the drum. As a result, playback can start immediately.
To end standby mode, press the STANDBY button, turning it off.
If 8 minutes (value can be varied using setup menu item 501) elapse in standby mode, the unit automatically switches out of standby mode to protect the tape.
3STOP button
To stop playback, press this button, turning it on. When you stop playback, the unit switches to still playback.
Fault display function
The STOP button flashes when there is no external reference signal input or the input external reference signal is not synchronized to the input video signal.
4F FWD (fast forward) button
To fast forward the tape, press this button, turning it on.
5PLAY button
To start playback, press this button, turning it on.
To operate in capstan override mode
Hold down this button, and turn the search dial.
For details of capstan override mode, see page
6SERVO indicator
Lights when the drum servo and capstan servo are locked.
7REW (rewind) button
To rewind the tape, press this button, turning it on.
Parts of Function and Location 2 Chapter
..........................................................................................................................................................................................................
1)Stop mode: The state in which the device currently the subject of operation is stopped, and the STOP button is lit.
Chapter 2 Location and Function of Parts |