Parts of Function and Location 2 Chapter
q; ALARM indicator and KEY INHI indicator
ALARM indicator
This lights when a hardware error is detected on the unit, and goes off when the error is resolved.
When this indicator is lit, an error message appears in the time data/menu display section. If you are using the SDI OUTPUT 3 (SUPER) or COMPOSITE VIDEO OUTPUT 3 (SUPER) connector, then when the setting of F4 (CHARA) in function menu page 4 is ON, the error message also appears on the monitor screen.
For details on error messages, refer to Section
KEY INHI (inhibit) indicator
This indicator lights when the KEY INHIBIT switch on the switch panel (see page
qa DMC playback control section
1DMC EDIT button
2MEMORY indicator
3DELETE button
4TRIM buttons
| 5 DMC playback control | |
|
| point setting buttons |
| TRIM |
|
| IN | PLAY OUT |
DMC EDIT | DELETE | ENTRY |
|
| |
MEMORY |
| |
LEARN | CUE/PLAY |
|
| IN | STUNT OUT |
6CUE/PLAY button
7LEARN button
1DMC EDIT button
To carry out recording of playback at any speed between
For playback in feed mode, hold down this button and press the PLAY button.
Playback in feed mode requires a setting of extended menu item 111.
2MEMORY indicator
When memorizing the playback speed using the DMC EDIT button, this indicator flashes as the playback speed is captured to memory, and lights continuously once the speed is captured.
3DELETE button
This deletes an existing DMC playback control point. Hold down this button and press the STUNT IN, STUNT OUT, PLAY IN, or PLAY OUT button which is lit, indicating an existing DMC playback control point, to delete the corresponding DMC playback control point. The button either goes off or flashes. When the button flashes, it is necessary to set the deleted DMC playback control point again.
To cancel the DMC mode, hold down the DMC button and press the DELETE button.
4TRIM buttons
Use these buttons to trim a DMC playback control point to
Hold down the STUNT IN, STUNT OUT, PLAY IN, or PLAY OUT button, and press one of these buttons. The ‘+’ button advances the corresponding edit point by one frame, and the
Pressing one of these buttons while holding down the PLAY button adjusts the tape speed by +8% or
5DMC playback control point setting buttons STUNT IN button and STUNT OUT button
To set a speed variation start or end point, hold down the STUNT IN button or STUNT OUT button, and press the ENTRY button.
After you have made the setting, pressing the STUNT IN button or STUNT OUT button displays the speed variation start or end point set in time data display area 2.
PLAY IN button and PLAY OUT button
To set an
After you have made the setting, pressing the PLAY IN button or PLAY OUT button displays the