ENTRY button
Use this for setting DMC playback control points and so on.
•To set a speed variation start or end point: Hold down the STUNT IN button or STUNT OUT button, and press this button.
•To set an
6CUE/PLAY (cue up/playback) button
After setting an
7LEARN button
After setting a speed variation start point (STUNT IN point) and a speed variation end point (STUNT OUT point), pressing this button makes the tape start running. You can then use the search dial to vary the tape speed, which is automatically stored in memory. After thus storing the tape speed variation in memory, pressing this button starts an automatic playback between the speed variation start and end points at the stored speed.
qs Shot mark section
1LIST button
2REC/ERASE indicator
LIST GOOD SHOT MARK |
|
REC/ | 3 MARK button |
ERASE |
1LIST button
Use this button to read in and list shot marks.
2REC/ERASE indicator
This lights in the state in which writing, amending, and deleting of shot marks is enabled and flashes while a shot mark is actually being written, amended or deleted.
3MARK button
Hold this button down for 2 seconds or more, to enable writing, amending, and deleting of shot marks.
Parts of Function and Location 2 Chapter
Chapter 2 Location and Function of Parts