To access the switch panel, open the lower control panel.
On how to open the lower control panel, see the figure on page
Parts of Function and Location 2 Chapter
1KEY INHIBIT switch
2PANEL SELECT switch
3CONTROL PANEL connector
KEY INHIBIT PANEL SELECT | CONTROL PANEL |
ON OFF REAR FRONT
4 Memory card ejection button
5Memory card slot
1KEY INHIBIT switch
Moving this switch to the ON position disables the controls on the upper and lower control panels.
You can specify which buttons and knobs are disabled in setup menu item 118.
2PANEL SELECT switch
In addition to the lower control panel, you can connect a similar control panel to this unit. When two control panels are connected to the unit, the PANEL SELECT switch is used to specify which panel be enabled to control the unit.
FRONT: Enables the control panel connected to the CONTROL PANEL connector on the switch panel.
REAR: Enables the control panel connected to the CONTROL PANEL connector on the connector panel. When setup menu item 117 is set to PARA, this switch position also enables the control panel connected to the CONTROL PANEL connector on the switch panel.
3CONTROL PANEL connector
Plug in the lower control panel connection cable.
4Memory card ejection button
Press to eject a memory card from the memory card slot.
5Memory card slot
Insert a memory card to update this unit’s firmware. You can save or load setup menu settings onto the memory card.
For details on firmware update, refer to the Maintenance Manual Volume 1.